A qualified professional should install, start up and perform maintenance on the system, closely following the installation instructions and all instructions that appear in this manual.
This system cannot be connected to a domestic power line. Make sure that the characteristics of the electrical installation meet the following requirements: 3 phases, 400 V phase to phase and 230 V phase to neutral.
It is compulsory to comply with all the applicable electrical safety regulations of the country in which the system is installed.
The safety of people and materials must be ensured. You must comply with the established safety regulations and codes.
The system’s electrical input must always be protected by a highly sensitive 30 mA residual current device (RCD).
Only use a high-quality connection, with a suitable cable cross-sectional area and proper earthing.
Make sure that the thermal magnetic circuit breakers have been calibrated according to energy consumption (amperage).
Do not use the electrical cabinet to connect other devices.
The maximum values that appear on the electrical panel must never be exceeded.
It is not permitted to make any modifications without the manufacturer’s express consent.
Only use original spare parts supplied by the manufacturer.
Some parts of the equipment operate at a very dangerous high voltage. Do not handle them unless the system is fully disconnected from the power supply or if the start-up devices are not locked out.
The maximum values that appear on the power distribution board must never exceed the recommended amperage.
Check the cables and hydraulic devices before starting the system or connecting it to the mains supply.
Make sure that no electrical component is in contact with the water.
Do not handle the equipment with wet feet.
The manufacturer will not be liable for any damage caused by installing unauthorized accessories or any damage caused by improper handling by unqualified persons. Contact your authorized dealer or technical support service if you have any questions or require technical assistance.
ATTENTION A proper earth connection is essential. The building’s earth circuit must always be in a perfect condition to guarantee the safety of the hot tub user. If in doubt, get a suitably qualified person to check your earth circuit. The manufacturer will not be liable for any injury or damage caused by inadequate maintenance of the earth circuit.
