The fill solenoid valve, which is activated manually from the mechanical switch on the furniture panel, allows the water, which has already been mixed at the desired temperature, to flow into the spa. Filling takes place through the waterfall.
Spa is filling to L1 massage sensor, at that point control panel functions are activated automatically. Then continues up to L2 level sensor detection, when filling cycle is automatically closed once the water level is stabilized. If the manual button is not pressed again, blue flashing light becomes solid and the auto-fi ll function remains activated automatically in case the level drops again due to overflow or evaporation.
Filling by mechanical switch
Flashing blue light is activated during filling cycle until the water level sensor is detected, then filling electro valve closes automatically. (filling mode switch picture).
NOTE: Filling waterfall should open and close two or three cycles during maximum water level stabilization process.
Flashing blue light stabilizes when spa is fully filled.
During filling stable blue light, filling cycle will be activated automatically in case of evaporation or overflow of the internal water until maximum water level again.
NOTE: If the switch is manually disactivated once filled, it will not fill automatically if the water level decrease.
Automatically, if L2 sensor does not detect water, it fills again.
See section 6.2. Water maintenance to see the specifications that should be considered regarding the water’s characteristics.
The use of tap water for filling the spa is recommended to reduce the influence of unwanted substances such as minerals.
Adequate water supply is required for filling the spa in compliance with all local water use regulations, and the parameters should be adjusted before the spa is used for the first time.
